[mythtv-users] lirc

[Sergei Gerasenko]

Both methods confirm that lirc is compiled in. There are no errors on
start-up. I think that for some reason lircrc is just not found. I don't
know if it means anything but strace shows no attempt to read that file.
The only lines about lirc are: 

open("/usr/local/lib/liblirc_client.so.0", O_RDONLY) = 3
read(3, "\177ELF\1\1\1\0\0\0\0\0\0\0\0\0\3\0\3\0\1\0\0\0`\r\0\000"..., 512) = 512

On Sat, Sep 30, 2006 at 08:49:17PM +0100, Robin Hill wrote:
> On Sat Sep 30, 2006 at 03:32:59PM -0400, Sergei Gerasenko wrote:
> 
> > Some time ago I upgraded from 0.18 to 0.20. lirc worked fine under 0.18.
> > I compiled 0.20 from scratch. 
> > 
> > irw reports correct key presses but mythfrontend doesn't respond to
> > remote commands. 
> > 
> > Just to be sure, how do I check if lirc support WAS compiled in? I
> > re-ran configure to see the output and by default the support is
> > included.  I'm pretty sure that when I compiled myth, I ran configure
> > without any parameters.
> > 
> > Any ideas?
> > 
> If you run ldd against mythfrontend then you should see it linked
> against liblirc_client.  Have you checked for any errors in the
> mythfrontend output (run it from a console if you're not logging the
> output normally)?  It should print out an error if it's failing to open
> the lirc device (as mine is at the moment - grr).
> 
> Cheers,
>         Robin
> 
> -- 
>      ___        
>     ( ' }     |       Robin Hill        <myth at robinhill.me.uk>  |
>    / / )      | Little Jim says ....                            |
>   // !!       |      "He fallen in de water !!"                 |



> _______________________________________________
> mythtv-users mailing list
> mythtv-users at mythtv.org
> http://mythtv.org/cgi-bin/mailman/listinfo/mythtv-users


-- 

Sergei Gerasenko
IT Department
PublicSchoolWORKS
Phone: (513)-631-6111