[mythtv-users] Hardware to support HD and Pvr-350

Joel Turner jturner421 at aol.com
Fri Nov 24 17:42:30 UTC 2006


On Nov 24, 2006, at 12:11 AM, nik gibson wrote:

> Hello,
>
> Does anyone have a HD, dual card motherboard success story?  I've  
> tried building a myth box on older hardware and it's just a huge  
> time wasting exercise so this time I'd like to do it right and buy  
> the proper hardware up front.
>

Nik,

I built a box with similar goals in April of this year.  I'm running  
an AMD based system with an Athlon 3500+, Epox 9NPA Ultra+   
motherboard, Leadtek PX6200 TC-64-H (supports composite out if you  
want) and a pcHDTV 3000.  I originally used the pcHDTV 3000 with QAM  
but now use it for OTA as I do captures from the firewire port of my  
cable box.  My provider, Charter in WI, does not encrypt channels  
1-99 over firewire. I have a second cable box which is dedicated to a  
PVR-350 that captures all channels including the premium ones. Since  
I live in an apartment and an outdoor antenna is not possible, I use  
a Terk HDTVLP Indoor antenna which has worked very well for me.   
Amazon had them for about $40.00 in August but I see they are now  
running at about $80.00  I am able to pull in all HD content in my  
area and it works significantly better than firewire capture (less  
artifacts). This setup gives me three tuners and is extremely  
flexible since I can record two HD channels at any time or two non  
premium channels at any time.

I've been pleased with this setup and processor load is about 70%  
when watching HD content. I've never dropped frames nor do I have  
stuttering problems.  I have not found a need to use XvMC with this  
class of processor under normal use. I compiled from source and  
followed the hints in maximizing performance on the wiki especially  
dealing with PCI latency. If I were to do it again I'd probably go  
for an x2 3800+ or higher for AMD.  One area where performance is an  
issue with this processor is commercial detection and transcoding of  
HD content.  A dual core setup would help for transcoding and XvMC  
might help in speeding up commercial detection by allowing you to  
dedicate more processor speed to the process. If you do not plan to  
transcode, I highly suggest at least 400-600Gb of hard disk space.   
This seems like overkill, but if you are busy and are queuing  
programs up, several weeks of programming can easily eat 200 - 300 GB  
of space.  I have found that HD programs average about 7GB per hour  
and SD programming at 2.2GB per hour. Toss in movies, the occasional  
PBS nature show, etc.. disk space disappears rapidly.

Good luck

--Joel


More information about the mythtv-users mailing list