[mythtv-users] Myth .20 and DirecTV D11 receiver

Rich West Rich.West at wesmo.com
Wed Nov 15 16:56:40 UTC 2006


>
>> trying to use Myth .20 with a DirecTV D11 receiver, and all I get is
>> digital static. I noticed a Macrovision label on the bottom of the
>> receiver, which makes me think there's some sort of copy protection
>> going on. I'm using the receiver's coax out to my Hauppauge PVX-350's
>> TV-in, then using the PVX350's AV-out to my TV. That setup worked fine
>> with basic cable, and the AV-out to my TV works fine with shows that
>> were recorded from the basic cable.
>>
>> Anyone have any success with that particular receiver?
>>     
>
> You have to tune your capture card to channel 3 and use an irblaster  
> or serial cable connection to the D11 to change the channel on the  
> box. There's more info on what cables to use and the channel change  
> script to use on the wiki.

To clarify, you have to tune your capture card to the same channel that
you have the D11 set to.  There's a switch on the back (to the left of
the S-Video port) which sets the D11 to output on either Channel 3 or
Channel 4.  Once you set that, make sure that your myth box's tuner card
is also set to that channel (ivtv-tune --channel 3).

With the D11, there is no home control port (low-speed data port), so
you will have to use an irblaster in order to have MythTV change channels.

-Rich


More information about the mythtv-users mailing list