[mythtv-users] PVR-150 Radio

[Andrew]

Does anyone know how to get the PVR-150 radio to work? It seems like the ivtv modules recognizes it.


ivtv:  ======================  NEXT CARD  ======================
ivtv1: Autodetected WinTV PVR 150 card (cx23416 based)
ACPI: PCI Interrupt 0000:02:0a.0[A] -> GSI 19 (level, low) -> IRQ 17
wm8775 1-001b: chip found @ 0x36 (ivtv i2c driver #1)
ivtv1: i2c attach to card #1 ok [client=wm8775, addr=1b]
tuner 1-0061: chip found @ 0xc2 (ivtv i2c driver #1)
ivtv1: i2c attach to card #1 ok [client=(tuner unset), addr=61]
tda9887 1-0043: chip found @ 0x86 (ivtv i2c driver #1)
ivtv1: i2c attach to card #1 ok [client=tda9887, addr=43]
ivtv1: i2c attach to card #1 ok [client=tveeprom, addr=50]
cx25840 1-0044: cx25843-23 found @ 0x88 (ivtv i2c driver #1)
cx25840 1-0044: loaded v4l-cx25840.fw firmware (14264 bytes)
ivtv1: i2c attach to card #1 ok [client=cx25840, addr=44]
tveeprom 1-0050: Hauppauge model 26552, rev F0A3, serial# 8928722
tveeprom 1-0050: tuner model is TCL MFNM05-4 (idx 103, type 43)
tveeprom 1-0050: TV standards NTSC(M) (eeprom 0x08)
tveeprom 1-0050: audio processor is CX25843 (idx 37)
tveeprom 1-0050: decoder processor is CX25843 (idx 30)
tveeprom 1-0050: has radio, has no IR remote
ivtv1: loaded v4l-cx2341x-enc.fw firmware (262144 bytes)
ivtv1: Encoder revision: 0x02050032
ivtv1: Allocate DMA encoder MPEG stream: 128 x 32768 buffers (4096KB total)
ivtv1: Allocate DMA encoder YUV stream: 194 x 10800 buffers (2048KB total)
ivtv1: Allocate DMA encoder VBI stream: 120 x 17472 buffers (2048KB total)
ivtv1: Allocate DMA encoder PCM audio stream: 455 x 4608 buffers (2048KB total)
ivtv1: Create encoder radio stream
tuner 1-0061: type set to 43 (Philips NTSC MK3 (FM1236MK3 or FM1236/F))
ivtv1: Initialized WinTV PVR 150, card #1
ivtv:  ====================  END INIT IVTV  ====================