[mythtv-users] Directv channel change script directv.pl
Jeff "Muddy" Waters
mythtvlist at muddysmind.com
Wed Sep 7 14:11:16 UTC 2005
On Thu, 2005-08-18 at 10:05 -0400, David Morris wrote:
> Check your serial cable to the sat box? If you just patched up a cheap
> phone line as a serial cable or have a loosely cimped or soldered
> connector, that could be your problem especially if the cable is run
> near other cables and noisy components. RS232 is very susceptible to
> noise, which is why you should always uses shielded cable. Dropping a
> single character is often indicative of noise, but if it's always the
> first character then it could be a timing issue, like the UART on one
> end or the the other isn't quite initialized fully before the first
> character is sent.
>
> David
>
> djg at pdp8.net wrote:
>
> > I had a couple reports of occasional changes to wrong channel with
> >my script directv.pl with D10-100 boxes using the new firmware. I have
> >updated the script to query the channel and try again if you are using the
> >setup_channel command. New version at
> >http://www.pdp8.net/directv/directv.shtml
> >
> >It looks like the box takes the remote codes and return the ok response
> >but actually looses the first digit sometimes. This can also happen
> >with the D10-200.
> >
> >
> >------------------------------------------------------------------------
> >
> >_______________________________________________
> >mythtv-users mailing list
> >mythtv-users at mythtv.org
> >http://mythtv.org/cgi-bin/mailman/listinfo/mythtv-users
> >
> >
>
> _______________________________________________
> mythtv-users mailing list
> mythtv-users at mythtv.org
> http://mythtv.org/cgi-bin/mailman/listinfo/mythtv-users
Has anyone been able to get the D10-300 boxes working with the
directv.pl script or satcontrol script?
More information about the mythtv-users
mailing list