[mythtv-users] Cannot get signal from PVR-250 component input to display on the screen

[Paul Olson]

Hello-
    New to Mythtv, have had a lot of success with the main features, but 
am stuck at a few points.  Would appreciate any assistance.

    I have connected a VCR to the component video input (also made the 
audio connection).  When I fire up the  VCR and switch the card to that 
input, I hear the audio but do not see any video on the display; I just 
see a blank screen.  Cable is ok, when I  connect those  cables to the 
TV, the video displays fine.

    I am fairly certain that I have something wrong in the card setup, 
byt I have not been able to isolate my mistake.  Can someone point me in 
the right direction?

    I am newbie, and am pretty sure I have left out some basic but 
necessary troubleshooting information.  LMK what I need to provide and I 
will dig it up.

TIA

Paulo