[mythtv-users] DCT-6200 w/ FireWire -- Looking for Input..
Big Wave Dave
bigwavedave at gmail.com
Thu Mar 31 07:11:15 UTC 2005
<--snip-->
> To get the right modules loaded, I just have only these two lines in
> modprobe.conf:
>
> alias ieee1394-controller ohci1394
> install ohci1394 /sbin/modprobe raw1394; /sbin/modprobe --ignore-install
> ohci1394
>
> And that's it.
So, I picked up a FireWire card to give this all a shot. Everything
seems fine in Dmesg and FC3 recognized the card on boot.
I compiled 6200ch and tried to run it, but it says it can't find it.
Here's the output of "plugreport" and "6200ch":
Host Adapter 0
==============
Node 0 GUID 0x0011060000003348
------------------------------
libiec61883 error: error reading oMPR
libiec61883 error: error reading iMPR
Node 1 GUID 0x0012c9fffe372faa
------------------------------
oMPR n_plugs=1, data_rate=2, bcast_channel=63
oPCR[0] online=1, bcast_connection=0, n_p2p_connections=0
channel=0, data_rate=2, overhead_id=0, payload=376
iMPR n_plugs=0, data_rate=2
[root at dolph contrib]# ./6200ch -v 704
node 1: vendor_id = 0x000012c9 model_id = 0x0000620a
Could not find Motorola DCT-6200 on the 1394 bus.
Also, as a side note... To get 6200ch to compile I ended up installing
the "-devel" versions of the the ieee1394 packages.
Thanks,
Dave
----------------------------------------------------------------
Are Your Friends Lemmings?
-- http://www.lemmingshirts.com
More information about the mythtv-users
mailing list