[mythtv-users] FC3, lirc and irman

[hondaman]

Thanks Andy, Jerod and Jeff.  That will give me enough information to 
beat my head against for a while :)

Jeff Wormsley wrote:

> hondaman wrote:
>
>> I got my irman in the mail today, and have had no luck getting it to 
>> do anything.  I have this in my modprobe.conf (as per Jarod's guide)
>>
>> options lirc_serial irq=3 io=0x2f8
>> install lirc_serial /bin/setserial /dev/ttyS1 uart none ;\
>>    /sbin/modprobe --ignore-install lirc_serial
>>
>> When I do lsmod, i dont see any lirc drivers listed.  If I do depmod 
>> -a, still nothing.  If I do modprobe lirc_serial, then I get
>> Module                  Size  Used by
>> lirc_serial            11424  0
>> lirc_dev               11148  1 lirc_serial
>>
>> lircd then starts ok.  When I run irw, however, I get no response 
>> from my remote.  I am using the pvr-250 remote (grey top, black 
>> bottom, with the red,green,yellow, and blue buttons along the bottom) 
>> with the corresponding lircd.conf.  I imagine Im doing a hundred 
>> things wrong.  Could someone please offer some advice?  I'm seriously 
>> stuck.
>>
> A few things to look for:
>
> 1. You don't need anything in modprobe.conf
>
> 2. Edit /etc/init.d/lircd and change the daemon line to read as follows:
>
> daemon lircd --driver=irman --device=/dev/ttyS0
>
> (Change ttyS0 to ttyS1 if you are on COM2)
>
> 3. Make sure you have the right lircd.conf file.  If IRW shows no 
> button names, chances are you have the wrong one (or the wrong serial 
> port selected).
>
> HTH,
> Jeff.
>
> _______________________________________________
> mythtv-users mailing list
> mythtv-users at mythtv.org
> http://mythtv.org/cgi-bin/mailman/listinfo/mythtv-users
>
>
>