[mythtv-users] Haupauge PVR 150

Tim Hamer tdh1 at cec.wustl.edu
Wed Jun 29 20:26:30 UTC 2005


this is the problem, at least part of it

Unable to open FW file '/lib/modules/HcwMakoA.ROM'.

you need to copy this file from the hauppauge driver cd.

Paul Furtado wrote:
> I'm new to linux i decided to to start using it as a mythtv box. I
> followed the howto on wilsonet.com to install it on fedora. I
> installed it fine and setup xmltv and then i purchased the PVR 150
> model 1024 from newegg.com. I downloaded and installed IvTv using yum
> and atrpms for fedora core 3 at-bleeding. Then i followed the other
> instructions in the howto guide to modify the modprobe.conf and start
> ivtv. I started the mythtvsetup and I chose the standard V4L capture
> card and video 0. Then i finished the rest of the setup and i exited.
> I went into the mythtv frontend and i hit watch tv and i was greeted
> by a black screen. I tried pressing Esc and it would not exit. I was
> forced to restart. Upon restart i ran setup again and it did not
> detect Video0 so i exited then started ivtv and then ran setup again
> and it detected video0 but it apparently found 2tv tuners 2svideo
> ports and 3 composite ports and i only have 1 tuner, 1svideo, 1
> composite. Heres my ivtv log
> Jun 29 14:33:19 localhost kernel: ivtv: ==================== START
> INIT IVTV ====================
> Jun 29 14:33:19 localhost kernel: ivtv: version 0.3.5 (l) loading
> Jun 29 14:33:19 localhost kernel: ivtv: Linux version: 2.6.11-1.27_FC3
> 686 REGPARM 4KSTACKS gcc-3.4
> Jun 29 14:33:19 localhost kernel: ivtv: In case of problems please
> include the debug info
> Jun 29 14:33:19 localhost kernel: ivtv: between the START INIT IVTV
> and END INIT IVTV lines when
> Jun 29 14:33:19 localhost kernel: ivtv: mailing the ivtv-devel mailinglist.
> Jun 29 14:33:19 localhost kernel: ivtv: Autodetected WinTV PVR 150 card
> Jun 29 14:33:19 localhost kernel: ivtv: Found an iTVC16 based chip
> Jun 29 14:33:19 localhost kernel: ACPI: PCI interrupt 0000:00:0e.0[A]
> -> GSI 10 (level, low) -> IRQ 10
> Jun 29 14:33:19 localhost kernel: ivtv: Unreasonably low latency
> timer, setting to 64 (was 32)
> Jun 29 14:33:19 localhost kernel: ivtv: XXX PCI device: 0x0730 vendor: 0x1039
> Jun 29 14:33:19 localhost kernel: tveeprom: Hauppauge: model = 26552,
> rev = B268, serial# = 7970919
> Jun 29 14:33:20 localhost kernel: tveeprom: tuner = LG TAPE H001F MK3
> (idx = 68, type = 47)
> Jun 29 14:33:20 localhost kernel: tveeprom: tuner fmt = NTSC(M)
> (eeprom = 0x08, v4l2 = 0x00001000)
> Jun 29 14:33:20 localhost kernel: tveeprom: audio_processor = MSP3410D
> (type = 5)
> Jun 29 14:33:20 localhost kernel: ivtv: i2c attach [client=tveeprom[50],ok]
> Jun 29 14:33:20 localhost kernel: ivtv: Tuner Type 47, Tuner formats
> 0x00001000, Radio: yes, Model 0x00892598, Revision 0x00000001
> Jun 29 14:33:21 localhost kernel: ivtv: Radio detected
> Jun 29 14:33:21 localhost kernel: tuner: Ignoring new-style parameters
> in presence of obsolete ones
> Jun 29 14:33:21 localhost kernel: tuner: chip found at addr 0xc2
> i2c-bus ivtv i2c driver #0
> Jun 29 14:33:21 localhost kernel: ivtv: i2c attach [client=(tuner unset),ok]
> Jun 29 14:33:22 localhost kernel: cx25840: Unable to open FW file
> '/lib/modules/HcwMakoA.ROM'.
> Jun 29 14:33:22 localhost kernel: cx25840: Failed to load any FW image file
> Jun 29 14:33:22 localhost kernel: ivtv: i2c attach [client=cx25840[50],ok]
> Jun 29 14:33:22 localhost kernel: ivtv: i2c attach [client=wm8775[50],ok]
> Jun 29 14:33:22 localhost kernel: ivtv: Encoder revision: 0x02040024
> Jun 29 14:33:22 localhost kernel: ivtv: Encoder Firmware may be buggy,
> use version 0x02040011
> Jun 29 14:33:22 localhost kernel: ivtv: Configuring WinTV PVR 150 card
> with 5 streams
> Jun 29 14:33:22 localhost kernel: ivtv: Registered v4l2 device,
> streamtype 0 minor 0
> Jun 29 14:33:22 localhost kernel: ivtv: Create DMA stream 0 using 128
> 16384 byte buffers  0 kbytes total
> Jun 29 14:33:22 localhost kernel: ivtv: Registered v4l2 device,
> streamtype 1 minor 32
> Jun 29 14:33:22 localhost kernel: ivtv: Create DMA stream 1 using 97
> 21600 byte buffers  0 kbytes total
> Jun 29 14:33:22 localhost kernel: ivtv: Registered v4l2 device,
> streamtype 2 minor 224
> Jun 29 14:33:22 localhost kernel: ivtv: Create DMA stream 2 using 60
> 34656 byte buffers  0 kbytes total
> Jun 29 14:33:22 localhost kernel: ivtv: Registered v4l2 device,
> streamtype 3 minor 24
> Jun 29 14:33:22 localhost kernel: ivtv: Create DMA stream 3 using 455
> 4608 byte buffers  0 kbytes total
> Jun 29 14:33:22 localhost kernel: ivtv: Registered v4l2 device,
> streamtype 4 minor 64
> Jun 29 14:33:22 localhost kernel: ivtv: Create stream 4 
> Jun 29 14:33:22 localhost kernel: ivtv: Setting Tuner 47
> Jun 29 14:33:22 localhost kernel: tuner: type set to 47 (LG NTSC (TAPE
> series)) by ivtv i2c driver #0
> Jun 29 14:33:22 localhost kernel: ivtv: Switching standard to NTSC.
> Jun 29 14:33:22 localhost kernel: ivtv: Initialized WinTV PVR 150, card #0
> Jun 29 14:33:22 localhost kernel: ivtv: ====================  END INIT
> IVTV  ====================
> 
> Thanks for any help in advance,
> Paul
> _______________________________________________
> mythtv-users mailing list
> mythtv-users at mythtv.org
> http://mythtv.org/cgi-bin/mailman/listinfo/mythtv-users
> 


More information about the mythtv-users mailing list