[mythtv-users] air2pc off ebay?

[Dan Rampton]

Thanks Steve, great directions.  I just hadn't applied the DVB
patches.  It's getting closer to working now.  :-)

Jul 25 07:57:45 goose kernel: b2c2-flexcop: B2C2 FlexcopII/II(b)/III
digital TV receiver chip loaded successfully
Jul 25 07:57:45 goose kernel: flexcop-pci: will use the HW PID filter.
Jul 25 07:57:45 goose kernel: flexcop-pci: card revision 2
Jul 25 07:57:45 goose kernel: ACPI: PCI Interrupt Link [LNK4] enabled at IRQ 3
Jul 25 07:57:45 goose kernel: ACPI: PCI Interrupt 0000:01:09.0[A] ->
Link [LNK4] -> GSI 3 (level, low) -> IRQ 3
Jul 25 07:57:45 goose kernel: DVB: registering new adapter (FlexCop
Digital TV device).
Jul 25 07:57:45 goose kernel: b2c2-flexcop: MAC address = 00:d0:d7:30:19:69
Jul 25 07:57:45 goose kernel: b2c2-flexcop: i2c master_xfer failed
Jul 25 07:57:45 goose last message repeated 2 times
Jul 25 07:57:45 goose kernel: i2c_readbytes: i2c read error (addr 0a,
err == -121)
Jul 25 07:57:45 goose kernel: bcm3510: Revision: 0x1, Layer: 0xb.
Jul 25 07:57:45 goose kernel: b2c2-flexcop: found the bcm3510 at i2c
address: 0x0f
Jul 25 07:57:45 goose kernel: DVB: registering frontend 0 (Broadcom
BCM3510 VSB/QAM frontend)...
Jul 25 07:57:45 goose kernel: b2c2-flexcop: initialization of
'Air2PC/AirStar 2 ATSC 1st generation' at the 'PCI' bus controlled by
a 'FlexCopIIb' complete
Jul 25 07:57:45 goose kernel: ACPI: PCI Interrupt Link [LNK3] enabled at IRQ 11
Jul 25 07:57:45 goose kernel: ACPI: PCI Interrupt 0000:01:08.0[A] ->
Link [LNK3] -> GSI 11 (level, low) -> IRQ 11

[root at goose ~]# /usr/local/bin/azap KCBS
using '/dev/dvb/adapter0/frontend0' and '/dev/dvb/adapter0/demux0'
tuning to 749000000 Hz
video pid 0x0000, audio pid 0x0000
status 00 | signal 0000 | snr 0000 | ber 00000000 | unc 00000000 |
status 00 | signal 0000 | snr 0000 | ber 00000000 | unc 00000000 |