[mythtv-users] What's changed in MythVideo / MPlayer?
Steve Frank
steve.frank at bevcore.com
Wed Sep 15 11:16:35 EDT 2004
What happens if you pass the parameters on the command line to Mplayer,
rather than with the config file?
> -----Original Message-----
> From: mythtv-users-bounces at mythtv.org
> [mailto:mythtv-users-bounces at mythtv.org] On Behalf Of Phil Bridges
> Sent: Wednesday, September 15, 2004 8:09 AM
> To: mythtv-users at mythtv.org
> Subject: [mythtv-users] What's changed in MythVideo / MPlayer?
>
>
> After upgrading to MythTV 0.16 (using Axel's RPMs), I
> suddenly have no AC3 content in my AC3-encoded AVIs.
> Everything is mixed back down to two-channel stereo.
>
> My mplayer config file reads (thanks, Jarod):
> # run full-screen
> fs=yes
> # zoom image to fill the screen
> zoom=yes
> # disable mplayer's usual verbosity
> really-quiet=yes
> # use XVideo for video output
> vo=xv
> # don't enable joystick
> nojoystick=yes
> # use alsa for audio out, through spdif
> ao=alsa1x:spdif
> # if ac3 audio, send raw stream to my amp, else fall back ac=hwac3,
>
> Looking at the verbose mode, it seems to think that there's
> no AC3 audio in the file, after finding it in the stream. I
> can post parts of the verbose output this evening if that
> would be helpful.
>
> Any suggestions?
> _______________________________________________
> mythtv-users mailing list
> mythtv-users at mythtv.org
> http://mythtv.org/cgi-bin/mailman/listinfo/mythtv-users
>
More information about the mythtv-users
mailing list