[mythtv-users] ATC-620 front logo

[Buechler, Mark R]

Can you give a link to this case?

Thanks, Mark.

-----Original Message-----
From: Dan Morphis [mailto:dan at milkcarton.com]
Sent: Wednesday, March 10, 2004 6:33 PM
To: Discussion about mythtv
Subject: Re: [mythtv-users] ATC-620 front logo


Dan, w/ the non-removable drive bays, did you figure out a way to screw 
in the non-exposed side to your dvd drive?  I have the same case, and 
for my dvd drive it really isn't an issue, but for my lcd panel, the 
non-exposed side I haven't been able to figure out how to get it screwed 
in so when I push buttons on the display it flexes. . .

-dan

Dan Conti wrote:
> They are good stuff. I have the 610 (i think) and have been really happy.
> The only things i wasn't keen on -
> 
> * No detachable drive bay, so it's a bit tricky to get the drives in
> (since you have to do it after the mb is in)
> * Cable wiring for the front panel wasn't optimal, i think i managed to
> run most of them out of the way and in a couple spots under the mb
> * It is nearly impossible to get a silent 60mm case fan; i ended up
> disconnecting the internal fan and removing it (leaving the grill). I have
> not had temp problems (athlon 1800+, zalman 5100-cu, and a low noise PSU)
> 
> I bought a pioneer slot loading dvd drive for it, and have been super
> happy overall, but getting it set up had some gotchas.
> 
> -Dan
> 




Bausch & Lomb
150 Years of Perfecting Vision, Enhancing Life (TM)






EMAIL DISCLAIMER 

Please Note: The information contained in this message may be privileged and
confidential, protected from disclosure, and/or intended only for the use of
the individual or entity named above. If the reader of this message is not
the intended recipient, or an employee or agent responsible for delivering
this message to the intended recipient, you are hereby notified that any
disclosure, distribution, copying or other dissemination of this
communication is strictly prohibited. If you received this communication in
error, please immediately reply to the sender, delete the message and
destroy all copies of it.

Thank You