I managed to run: remote_irrecord --device=/dev/remote filename and the
dots appear so I know that the IR Blaster is receiving signals from the
Scientific Atlanta remote.
It generated a conf file with the following data, however, when running
change_channel.csh 13 as per the directions, it does not change the
channel. A new PID number gets generated though.
Here's the output of the file remote_irrecord generated.
begin remote
name filename
bits 23
flags SPACE_ENC|CONST_LENGTH
eps 30
aeps 100
header 3329 3350
one 832 2510
zero 832 855
gap 100299
toggle_bit 0
begin codes
end codes
end remote
-------------
This data differs slightly from my /etc/remoted.conf file.
begin remote
name SA2000
flags CONST_LENGTH|RAW_CODES
eps 30
aeps 100
ptrail 0
repeat 0 0
gap 100240
Should I adjust the remoted.conf file to accomodate the additional info
that was created?
I am using a Scientific Atlanta E2050ER1 remote, along with a 3200 model
receiver.