[mythtv-users] Can't start up unless in X
Rob Willett
rob.mythtv at robertwillett.com
Sat Apr 17 05:03:22 EDT 2004
Problem has gone away.
I suspect it was due to me leaving a debug=1 statement next to the nxt600 module
install and me recompiling the kernel for a wholly different purpose.
I did look at lsmod before and after but couldn;t see any difference.
Oh well, c'eat la vie.
Rob.
Quoting Rob Willett <rob.mythtv at robertwillett.com>:
> Mike,
>
> I thought about that, I have an nvidia card and modprobe the nvideo
> module at boot up. Actually I don't modprobe, I insmod it. I'll
> nodprobe it and see if that works, I;ll check the contents of lsmod
> before and after though anyway.
>
> Thanks,
>
> Rob.
>
> Michael T. Dean wrote:
>
> > Rob Willett wrote:
> >
> >> I was getting loads of error messages when I start mythbackend from
> >> the command
> >> line before I start up X. There are no problems at all if I start
> >> mythback from
> >> a terminal session in X. Huh!
> >>
> >>
> > Perhaps X is initializing (and loading modules for) your capture
> > card. Try either a) loading the appropriate modules before starting
> > mythbackend, or b) adding the appropriate lines to your modules.conf
> > (assuming Linux 2.4) to "auto-load" your capture card modules (i.e.
> > alias, add above, add below, pre-install, post-install--whatever is
> > required for your card).
> >
> > HTH,
> > Mike
> >
> > _______________________________________________
> > mythtv-users mailing list
> > mythtv-users at mythtv.org
> > http://mythtv.org/cgi-bin/mailman/listinfo/mythtv-users
>
>
>
> _______________________________________________
> mythtv-users mailing list
> mythtv-users at mythtv.org
> http://mythtv.org/cgi-bin/mailman/listinfo/mythtv-users
>
-------------------------------------------------
This mail sent through IMP: http://horde.org/imp/
More information about the mythtv-users
mailing list