[mythtv-users] Another Audio Question, I need to figure this out
Isaac Richards
ijr at po.cwru.edu
Sat May 31 01:58:13 EDT 2003
On Saturday 31 May 2003 12:43 am, Chris Germano wrote:
> Ok I loaded the btaudio driver on bootup, and selected it to record through
> dsp3 [analog]. The only problem is now the audio is high pitched and starts
> and stops spiraticaly (the chipmunk effect). Obviously that would have to
> do with the frequency, but where and to what should I set that too? I tried
> all the frequencies on the myth setup where you define the capture card but
> they dont seam to affect it? Any ideas?
You should be using the digital dsp, most likely dsp2 if the analog is at
dsp3, locked to 32kHz.
Isaac
More information about the mythtv-users
mailing list