[mythtv-users] Install tips for RH9 and PVR250 owners for Myth
Ken VanDine
ken at bizrace.com
Sat May 24 15:25:19 EDT 2003
I have the same setup and it almost all works. I am having trouble with
lirc. The problems seems to be that lirc requires the bttv module be loaded
for (hardware detection i think). The bttv module won't load because I
don't have the hardware for it installed... I only of the PVR-250 installed.
I am using the latest cvs of lirc. lircd crashes with this error when I run
irw:
<from /var/log/lircd>
May 23 13:07:22 mythtv1 lircd 0.7.0pre1: lircd(hauppauge) ready
May 23 13:07:22 mythtv1 lircd 0.7.0pre1: accepted new client on /dev/lircd
May 23 13:07:22 mythtv1 lircd 0.7.0pre1: could not get hardware features
May 23 13:07:22 mythtv1 lircd 0.7.0pre1: this device driver does not support
the new LIRC interface
May 23 13:07:22 mythtv1 lircd 0.7.0pre1: make sure you use a current version
of the driver
May 23 13:07:22 mythtv1 lircd 0.7.0pre1: caught signal
</from /var/log/lircd>
<from /var/log/messages>
May 24 12:53:10 mythtv1 kernel: lirc_dev: IR Remote Control driver
registered, at major 61
May 24 12:53:14 mythtv1 kernel: bttv: driver version 0.7.104 loaded
May 24 12:53:14 mythtv1 kernel: bttv: using 4 buffers with 2080k (8320k
total) for capture
May 24 12:53:14 mythtv1 kernel: bttv: Host bridge is Intel Corp. 82815 815
Chipset Host Bridge and Memory Controller Hub
May 24 12:53:14 mythtv1 insmod: /lib/modules/2.4.20-13.9/kernel/drivers/
media/video/bttv.o: init_module: No such device
May 24 12:53:14 mythtv1 insmod: Hint: insmod errors can be caused by
incorrect module parameters, including invalid IO or IRQ parameters.
You may find more information in syslog or the output from dmesg
May 24 12:53:14 mythtv1 insmod: /lib/modules/2.4.20-13.9/kernel/drivers/
media/video/bttv.o: insmod bttv failed
May 24 12:53:14 mythtv1 modprobe: modprobe: Can't locate module rivatv
May 24 12:53:14 mythtv1 kernel: i2c-core.o: driver i2c ir driver registered.
May 24 12:53:14 mythtv1 kernel: lirc_i2c: chip found @ 0x18 (Hauppauge IR)
May 24 12:53:14 mythtv1 kernel: i2c-core.o: client [Hauppauge IR] registered
to adapter [ivtv i2c driver #0](pos. 3).
May 24 12:53:14 mythtv1 kernel: lirc_dev: lirc_register_plugin:sample_rate:
10
</from /var/log/messages>
Anyone have any advice?
TIA
--Ken
More information about the mythtv-users
mailing list