[mythtv] Ticket #2087: Clean up NTSC cable frequency tables
Michael T. Dean
mtdean at thirdcontact.com
Tue Jul 25 16:48:14 UTC 2006
On 07/25/06 12:40, Daniel Kristjansson wrote:
>On Tue, 2006-07-25 at 12:29 -0400, Michael T. Dean wrote:
>
>
>>On 07/25/06 11:51, Daniel Kristjansson wrote:
>>
>>>On Tue, 2006-07-25 at 01:22 -0400, Michael T. Dean wrote:
>>>
>>>>If that's not changed, the table created by
>>>>the "cablehigh0" definition is missing channels 93 and 94 (and those
>>>>that exist are at the wrong frequencies).
>>>>
>>>cablehigh should only include channels above 730Mhz in frequency, but the
>>>enumeration should match the tables...
>>>
>>730MHz? Currently for standard it starts at channel 78, which has a
>>center frequency of 549MHz.
>>
>Make that 530Mhz :)
>
>
Understood. :)
>>For this I think I should modify scanwizardhelper to label it "Cable ?RC
>>76+" and fix the enumeration to start at 76.
>>
>>
>I would probably call it "Cable High" and leave the actual channels out of
>it. But basically the enumeration should start at 76 for now. There is
>no exact cut-off, basically the cable providers tend to stick digital
>channels above the analog ones. cablehigh is intended to allow you to
>skip most of the low frequencies so that the scan doesn't spend minutes
>scanning channels where there probably aren't any digital transports. My
>first digital channels are in the 80's...
>
Sounds good. And, the channel numbers in the UI are likely to cause
more confusion than benefit.
Thanks for walking me through this. I'll get patches in #2087 shortly.
Mike
More information about the mythtv-dev
mailing list