[mythtv] Playback Problems
Hamish Moffatt
hamish at cloud.net.au
Fri Dec 3 09:05:24 UTC 2004
On Thu, Dec 02, 2004 at 01:38:24PM +0000, Ed Wildgoose wrote:
> Yes, but if you have a 60 or 72Hz refresh rate on the output device then
> myth appears to get completely confused. If you have 50Hz then I think
> it will sync nicely and perhaps drop a couple of frames per hour when
> the clocks diverge.
That's for PAL, right? I assume that for NTSC you need to run 60 Hz.
> >Too bad I can't lock my video and audio playback to the television
> >station's transmit clock, because they usually use very accurate
> >references.
>
> Well if you used DVB or perhaps ATSC then there is a clock broadcast in
> the stream on the PCR pid (often the same as the video pid). You could
> write some code to sync against this if you wanted.
I was thinking of a hardware frequency lock specifically.
Hamish
--
Hamish Moffatt VK3SB <hamish at debian.org> <hamish at cloud.net.au>
More information about the mythtv-dev
mailing list