[mythtv-commits] Ticket #11568: HVR-1600 stopped working
MythTV
noreply at mythtv.org
Thu May 30 01:43:46 UTC 2013
#11568: HVR-1600 stopped working
--------------------------------------+----------------------------------
Reporter: JH <jasonchiller@…> | Owner: danielk
Type: Bug Report - General | Status: new
Priority: minor | Milestone: unknown
Component: MythTV - Recording | Version: 0.26
Severity: medium | Keywords: tuner not recognized
Ticket locked: 0 |
--------------------------------------+----------------------------------
I installed mythbackend version 0.25 on Ubuntu 12.04 and successfully
recorded and watched several shows. I am using a Hauppauge HVR-1600 tuner
that is recording analog cable tv (NTSC). About two weeks after the
initial install I recorded another show but when I went to watch it, it
was just an hour of a blank red screen. When I ran mythtv-setup and went
to the tuner card setup section I noticed it said "Failed to open" in the
Probed info section on my tuner card that I had previously successfully
configured. The configuration I am using is Video device: /dev/video0 and
VBI device /dev/vbi0. When I looked at the log file for mythtv-setup and
mythbackend I only see the few entries which I listed below. I also
looked at syslog (see entries below) and from what I can tell the OS
successfully recognized my tuner. Also, when I look in /dev I see three
entries which are video0, video24 and video32. I have since upgraded to
version 0.26 but mythsetup still does not recognize my card.
Log Entry from mythtv-setup ->[[BR]]
mythtv-setup[4190]: E CoreContext cardutil.cpp:1990 (ProbeV4LAudioInputs)
ProbeAudioInputs() -> couldn't open device
Log Entries from mythbackend.log ->[[BR]]
May 28 22:03:51 hillermedia mythlogserver: mythbackend[1500]: E
CoreContext channelbase.cpp:1227 (CreateChannel) ChannelBase:
CreateChannel() Error: Failed to open device /dev/video0[[BR]]
May 28 22:03:51 hillermedia mythlogserver: mythbackend[1500]: E
CoreContext main_helpers.cpp:199 (setupTVs) Problem with capture cardsCard
1failed init[[BR]]
May 28 22:03:51 hillermedia mythlogserver: mythbackend[1500]: W
CoreContext main_helpers.cpp:214 (setupTVs) MythBackend: No valid capture
cards are defined in the database.[[BR]]
Log Entries from syslog-> [[BR]]
kernel: [ 2.205824] Linux video capture interface: v2.00 [[BR]]
kernel: [ 2.207910] cx18: Start initialization, version 1.5.1 [[BR]]
kernel: [ 2.207925] cx18-0: Initializing card 0 [[BR]]
kernel: [ 2.207927] cx18-0: Autodetected Hauppauge card [[BR]]
kernel: [ 2.207958] cx18 0000:05:01.0: PCI INT A -> GSI 18 (level, low)
-> IRQ 18 [[BR]]
kernel: [ 2.208032] cx18-0: Unreasonably low latency timer, setting to
64 (was 32) [[BR]]
kernel: [ 2.486978] tveeprom 17-0050: Hauppauge model 74021, rev C1B2,
serial# 1439597 [[BR]]
kernel: [ 2.486980] tveeprom 17-0050: MAC address is 00:0d:fe:15:f7:6d
[[BR]]
kernel: [ 2.486981] tveeprom 17-0050: tuner model is TCL M2523_5N_E
(idx 112, type 50) [[BR]]
kernel: [ 2.486982] tveeprom 17-0050: TV standards NTSC(M) (eeprom
0x08) [[BR]]
kernel: [ 2.486984] tveeprom 17-0050: audio processor is CX23418 (idx
38) [[BR]]
kernel: [ 2.486985] tveeprom 17-0050: decoder processor is CX23418 (idx
31) [[BR]]
kernel: [ 2.486986] tveeprom 17-0050: has no radio, has IR receiver,
has IR transmitter [[BR]]
kernel: [ 2.486987] cx18-0: Autodetected Hauppauge HVR-1600 [[BR]]
kernel: [ 2.486989] cx18-0: Simultaneous Digital and Analog TV capture
supported [[BR]]
kernel: [ 2.620454] tuner-simple 18-0061: creating new instance [[BR]]
kernel: [ 2.620455] tuner-simple 18-0061: type set to 50 (TCL 2002N)
[[BR]]
kernel: [ 2.623443] cx18-0: Registered device video0 for encoder MPEG
(64 x 32.00 kB) [[BR]]
kernel: [ 2.623446] DVB: registering new adapter (cx18) [[BR]]
kernel: [ 2.697626] MXL5005S: Attached at address 0x63 [[BR]]
kernel: [ 2.697629] DVB: registering adapter 0 frontend 0 (Samsung
S5H1409 QAM/8VSB Frontend)... [[BR]]
kernel: [ 2.697718] cx18-0: DVB Frontend registered [[BR]]
kernel: [ 2.697720] cx18-0: Registered DVB adapter0 for TS (32 x 32.00
kB) [[BR]]
kernel: [ 2.697747] cx18-0: Registered device video32 for encoder YUV
(20 x 101.25 kB) [[BR]]
kernel: [ 2.697778] cx18-0: Registered device vbi0 for encoder VBI (20
x 51984 bytes) [[BR]]
kernel: [ 2.697809] cx18-0: Registered device video24 for encoder PCM
audio (256 x 4.00 kB) [[BR]]
kernel: [ 2.697811] cx18-0: Initialized card: Hauppauge HVR-1600 [[BR]]
kernel: [ 2.697831] cx18: End initialization [[BR]]
kernel: [ 2.699336] cx18-alsa: module loading... [[BR]]
kernel: [ 2.762886] fbcon: inteldrmfb (fb0) is primary device [[BR]]
kernel: [ 2.762948] Console: switching to colour frame buffer device
240x67 [[BR]]
kernel: [ 2.762966] fb0: inteldrmfb frame buffer device [[BR]]
kernel: [ 2.762967] drm: registered panic notifier [[BR]]
kernel: [ 2.912433] cx18-0: loaded v4l-cx23418-cpu.fw firmware (158332
bytes)
--
Ticket URL: <http://code.mythtv.org/trac/ticket/11568>
MythTV <http://code.mythtv.org/trac>
MythTV Media Center
More information about the mythtv-commits
mailing list