<div dir="ltr">I moved my mythtv backend back to the original NUC now that I have the NUC fan repaired. I rsync'ed my files back, restored the database, and ran mythtv-setup on my NUC and saw the IP address had changed so I selected the new one.  <div><br></div><div>I finished testing out the system.  Later I saw that on reboot the NUC was back on Ethernet and not wifi so I disabled WiFi. I went back into mythtv-setup and tried to change the IP again, but now mythtv-setup has a segment fault. </div><div><br></div><div>Visually, mythtv-setup starts. shows the menu and then that disappears and you have the message boxes pop up asking if you want to start the backend and run mythfilldatabase.</div><div><br></div><div>I need to figure this out, so any help is appreciated.</div><div><br></div><div>Jim A<br><br></div></div>