<div dir="ltr">I'm testing how I'm going to migrate my backend to new hardware so I'll not screw it up when it's time to do it for real.<div><br></div><div>I built up the new hardware and got the mythtv frontend and backend working with HDHR tuners.</div><div><br></div><div>Next  copied over all my recordings from my production backend to the new hardware. Then I took a database backup and restored it using the --drop_database and --create_database options. </div><div><br></div><div>With the backend stopped for all this I went in with mythtv-setup and changed tuners, Video sources, connections, and Storage groups locations. So I had it working as a combo and ran into problems with remote front ends like FireTV 4k android mythfrontend. </div><div><br></div><div>I found the file with the bind_address=:: needed to be moved to mariadb.conf.d because of the search order. That allowed the FireTV to connect using the UPNP search. </div><div><br></div><div>But the mythconverg passwords that ended up in all my config.xml files was the password from the new hardware mythtv prior to restoring the database from the production backend.</div><div><br></div><div>So the $64,000 question is after a restore of the database, what is the password? the one from the restore file, or the one already in the database?</div><div><br></div><div>From what I see my old production database, where I got the backup file to restore on the new hardware is NOT the same database password that the new hardware is using after the restore.</div><div><br></div><div>If I can't figure this out, what is the process to change the new hardware database password to something I can be sure of lik 'mythtv'</div><div><br></div><div>Jim A</div><div><br></div></div>