<div dir="ltr"><div dir="ltr"><br></div><br><div class="gmail_quote"><div dir="ltr" class="gmail_attr">On Sat, Aug 22, 2020 at 10:19 AM Mike Bibbings <<a href="mailto:mike.bibbings@gmail.com">mike.bibbings@gmail.com</a>> wrote:<br></div><blockquote class="gmail_quote" style="margin:0px 0px 0px 0.8ex;border-left:1px solid rgb(204,204,204);padding-left:1ex"><br>
Jim,<br>
<br>
I have also used the hauppage kernel ppa in the past, but hauppauge have <br>
done a pretty good job at getting most of their changes into the V4L <br>
subsystem used in later kernels (I wish other suppliers e.g. TBS did this).<br>
<br>
When I upgraded from Xubuntu 16.04  to Xubuntu 18.04 (via clean install, <br>
not in-place upgrade)  and found my QuadHD card worked with mythtv, I <br>
just kept the Ubuntu kernel.<br>
<br>
The main advantage of the happauge ppa is that it is kept up to date <br>
with changes that hauppauge may make to their product lines e.g. new <br>
demod chip will get support much earlier than in Ubuntu.<br>
<br>
You are correct in that the firmware is not needed to the USA version <br>
(atsc) of the card.<br>
<br>
<br>
Mike<br>
<br><br></blockquote><div>Mike,</div><div><br></div><div>Since my QuadHD is from a 2019-02-19 order I did, I'm guessing it's old enough to work with the latest Ubuntu 20.04.1 kernel 5.4.0. I'll try picking the default Ubuntu kernel at boot and see. </div><div><br></div><div>If that works, I hope just uninstalling the Hauppauge stuff will go smoothly.</div><div><br></div><div>Jim A</div><div><br></div><div> </div></div></div>