<div dir="ltr">I noticed when I add an HDHomerun tuner in V31 mythtv-setup I pick which HDHR physical device I want by IP and I seem to be able to select all of them it finds on the network.<div><br></div><div>So I'm guessing that if I want to have 6 tuners available I can create 6 tuners in mythtv-setup and select the IP for my HDHR Quatro and Duo. I also deselect the Active EIT scanning so the tuners are not constantly in use since I'm using XMLTV EPG.</div><div><br></div><div>I'm guessing it creates a  pool of tuners to select from, and at record time if one is busy it moves on to another tuner either on the same device or the next HDHR.</div><div><br></div><div>If all the HDHR devices are connected to the same OTA antenna and receive the same channels then only one SchedulesDirect Video Source using a XMLTV grabber is needed.</div><div><br></div><div>I'll need 6 Input connections matching the Video source to the tuners.</div><div><br></div><div>I also increase the number of simultaneous recordings to 2. I think this helps if I'm recording back to back shows on the same channel with one recording overlapping the other by a minute or so. I think this saves a physical tuner.</div><div><br></div><div>From what I understand because mythtv v31 uses the TCP communication method instead of the older UDP method of talking to the HDHR, as long as the maximum number of tuners don't exceed 6 in my case, other devices like an iPad running the HDHR app will all share without issue.</div><div><br></div><div>So do I have this understanding about Mythtv v31 and HDHR right??</div><div><br></div><div>My testing says it does, but it's a lot of testing to confirm all of this.</div><div><br></div><div>Jim A<br><br></div></div>