<div dir="ltr"><div dir="ltr"><br></div><br><div class="gmail_quote"><div dir="ltr" class="gmail_attr">On Sat, Dec 7, 2019 at 8:17 PM Stephen Worthington <<a href="mailto:stephen_agent@jsw.gen.nz">stephen_agent@jsw.gen.nz</a>> wrote:<br></div><blockquote class="gmail_quote" style="margin:0px 0px 0px 0.8ex;border-left:1px solid rgb(204,204,204);padding-left:1ex">On Sat, 7 Dec 2019 14:28:42 -0500, you wrote:<br>
<br>
>It was insomnia testing 4am I started four recordings, then opened a<br>
>browser on my FE/BE and immediately the recordings failed no other network<br>
>traffic at all.<br>
<br>
So that makes it unlikely that it was a traffic problem that caused<br>
the bad recordings.<br>
<br>
When you say "failed", what exactly happened?  Did the recordings just<br>
stop, or did they complete but had lots of errors?<br>
<br>
>My router allows 1 top priority service 2 second level priority and ten<br>
>normal priority device staging. My wife's VoIP phone takes the top spot and<br>
>the HDHRs occupy the next two spots. This change was made prior the the<br>
>last test. The ethrenet switch is a "smart switch" maybe that is where I'm<br>
>getting into trouble?<br>
<br>
I am presuming that you have your MythTV box and HDHRs all connected<br>
to the same "smart switch" and on the same subnet.  If so, then the<br>
packets between the HDHRs and the MythTV box will never be going to<br>
the router, and will not be affected by its QoS operations.  The<br>
packets will be switched by the Ethernet switch between its ports<br>
without ever getting to the router.<br>
<br>
Ideally, you would want your switch to do DSCP QoS, but it is unlikely<br>
it is capable of that.  QoS in switches is usually only found in<br>
enterprise grade switches or top end consumer ones.  But you certainly<br>
should look up your switch to see if it is capable of doing DSCP QoS.<br>
<br>
I have an EdgeSwitch ES-24-LITE:<br>
<br>
<a href="https://www.ui.com/edgemax/edgeswitch-lite/" rel="noreferrer" target="_blank">https://www.ui.com/edgemax/edgeswitch-lite/</a><br>
<br>
which is an enterprise grade switch and has full QoS capabilities.<br>
That is one of the features I bought it for.  I have it configured to<br>
do DSCP priority on all ports, but I have never actually tested to see<br>
if it is working as I do not have any problems that would actually<br>
need DSCP to be working.<br>
_______________________________________________<br><br></blockquote><div><br></div><div>I use a Cisco-Linksys EZXS55W EtherFast 10/100 5-Port Workgroup Switch.</div><div>It has two HDHR and the Myth computer into it as well as the line going to my R6700 Nighthawk router. </div><div>No problems whatsoever since I made the changes to the Linux configuration.</div><div><br></div><div>Allen</div></div></div>