<div dir="ltr"><div dir="ltr"><div dir="ltr"><div dir="ltr"><br></div><br><div class="gmail_quote"><div dir="ltr">On Sat, Dec 22, 2018 at 3:27 AM Stephen Worthington <<a href="mailto:stephen_agent@jsw.gen.nz">stephen_agent@jsw.gen.nz</a>> wrote:<br></div><blockquote class="gmail_quote" style="margin:0px 0px 0px 0.8ex;border-left:1px solid rgb(204,204,204);padding-left:1ex">On Fri, 21 Dec 2018 23:23:03 -0500, you wrote:<br>
<br>
>On Fri, Dec 21, 2018 at 2:55 PM Daryl McDonald <<a href="mailto:darylangela@gmail.com" target="_blank">darylangela@gmail.com</a>><br>
>wrote:<br>
><br>
>><br>
>><br>
>> On Fri, Dec 21, 2018 at 1:38 PM Will Dormann <<a href="mailto:wdormann@gmail.com" target="_blank">wdormann@gmail.com</a>> wrote:<br>
>><br>
>>> On 12/20/18 7:33 PM, Stephen Worthington wrote:<br>
>>> > What is your motherboard?  There are known bugs in the device drivers<br>
>>> > for old Nvidia motherboards that make some drives do bad things - I<br>
>>> > have an old Nvidia board where my Samsung 1 Tbyte drive will not work<br>
>>> > - I have to run if from a PCIe SATA port.  I bisected the kernel and<br>
>>> > reported the changes that caused this, but to date it has not been<br>
>>> > fixed.<br>
>>><br>
>>> Interesting.   I had a problem with my old nVidia ION system (nVidia<br>
>>> MCP79) where I'd get bus errors with a SanDisk SSD.  I ended up swapping<br>
>>> it with another manufacturer's drive, and it seemed to be OK.  At this<br>
>>> point, I blamed it on the drive being defective.<br>
>>><br>
>>> The system in question has since been retired, so I probably shouldn't<br>
>>> care.  But I'm curious if you have any more details about this bug.<br>
>>><br>
>>><br>
>>> -WD<br>
>><br>
>> What I did last night is most likely a one-off. Earlier I had my power<br>
>> supply powering my HDHR and cable box. When that proved unreliable, I<br>
>> marrette'd the power wires back to a connector, which was also unreliable,<br>
>> so un-used and almost forgotten. Last night I took the connector off and<br>
>> dead-ended the four wires, hearing only one more pop afterwards, and that<br>
>> pop may have been re-connection of storage2. I will claim victory after I<br>
>> hear no pops tonight.<br>
>><br>
><br>
>The bad news is: I was wrong, the storage2 dropped out, so I powered down<br>
>and switched power and sata cables with storage3 (previous test was with<br>
>storage1) The good news is: since storage3 dropped out this time it is<br>
>almost certain that the mobo is at fault. The bad news is the mobo I<br>
>ordered is, apparently adrift in the Pacific somewhere. The good news is:<br>
>its Christmas time and friends and family aplenty will replace my need for<br>
>reliable Mythtv, for now, as I wait. Many thanks to everyone on this list,<br>
>and I wish you all a splendid season of Joy and Good Cheer!  Daryl<br>
<br>
Ouch!  I hate motherboard faults - they are often hard to pin down. At<br>
least you seem to be getting somewhere now with diagnosing this one.<br>
If it is a mobo problem, then it will likely only affect one or a pair<br>
of SATA ports, so the mobo may well be usable still if you add a PCIe<br>
SATA card to replace the bad ports (presuming you have room to do<br>
that).  It pays to put some tape over known bad ports, so you do not<br>
accidentally use them again.<br>
_______________________________________________<br>
mythtv-users mailing list<br>
<a href="mailto:mythtv-users@mythtv.org" target="_blank">mythtv-users@mythtv.org</a><br>
<a href="http://lists.mythtv.org/mailman/listinfo/mythtv-users" rel="noreferrer" target="_blank">http://lists.mythtv.org/mailman/listinfo/mythtv-users</a><br>
<a href="http://wiki.mythtv.org/Mailing_List_etiquette" rel="noreferrer" target="_blank">http://wiki.mythtv.org/Mailing_List_etiquette</a><br>
MythTV Forums: <a href="https://forum.mythtv.org" rel="noreferrer" target="_blank">https://forum.mythtv.org</a></blockquote><div><br></div><div>I switched sata ports of the Blueray drive with the storage2 drive, so storage2 is now into the PCI sata expansion card(Silicon Image, Inc. SiI 3114 [SATALink/SATARaid] Serial ATA Controller (rev 02)), of interest, storage2 became /dev/sda1 and mobo sata1 port with Kingston OS drive became /dev/sdb1 (previously /dev/sda1). Also of interest, after switching cables the box booted once but I had to use boot-repair for a reboot. As I started this e-mail I heard the pop twice as storage2 dismounted and remounted, no power cables wire switched this time.</div><div><br></div><div>Would this PCI card: Silicon Image, Inc. SiI 3114 [SATALink/SATARaid] Serial ATA Controller (rev 02) create an unwanted bottleneck if I were to plug all of my drives into it's four ports?</div></div></div></div></div>