<div dir="auto"><div><br><br><div class="gmail_quote"><div dir="ltr">On Fri, Nov 30, 2018, 8:57 PM Bob <<a href="mailto:mythtv@cox.net">mythtv@cox.net</a> wrote:<br></div><blockquote class="gmail_quote" style="margin:0 0 0 .8ex;border-left:1px #ccc solid;padding-left:1ex">On 11/8/18 2:14 PM, Will Dormann wrote:<br>
> On 11/8/18 10:39 AM, Dan Wilga wrote:<br>
>> I, and others, have<br>
>> successfully replaced these wall warts with a cable that connects<br>
>> directly to the PC's 5v power supply. I essentially took the Molex<br>
>> connector from a dead case fan, moved the "+" pin from the 12v position<br>
>> to 5v, chopped off the bad wall wart's cable, and wired it to the pins<br>
>> on the Molex connector. Remember: Polarity is crucial!<br>
> <br>
> <br>
> +1 on this strategy.  I've been running my HD-PVR off of my MythTV box's<br>
> DVR for a few years with zero trouble.   I just run the wire out of the<br>
> back of the MythTV box (via an expansion slot cover that has a hole in<br>
> it) and to the HD-PVR.<br>
> <br>
> Aside from being more reliable, one fewer wall wart is a neater setup!<br>
<br>
So, I made my attempt at a cable to replace my wall wart and my <br>
recordings are not working so good. After re-reading this, it appears I <br>
should *not* have used the 5V line even though the wall warts I have <br>
show 5V @ 2A, right?<br>
<br>
Interestingly, the HD-PVR does power-on and is assigned a device <br>
(/dev/video5 in this case). However, I attempted a 4 minute recording <br>
and actually recorded for about 1 second. The "blue" light turned off <br>
every 4 seconds, then back-on again.<br>
<br>
So, use the +12V line and not the +5V line?<br>
<br>
<br>
_______________________________________________<br>
mythtv-users mailing list<br>
<a href="mailto:mythtv-users@mythtv.org" target="_blank" rel="noreferrer">mythtv-users@mythtv.org</a><br>
<a href="http://lists.mythtv.org/mailman/listinfo/mythtv-users" rel="noreferrer noreferrer" target="_blank">http://lists.mythtv.org/mailman/listinfo/mythtv-users</a><br>
<a href="http://wiki.mythtv.org/Mailing_List_etiquette" rel="noreferrer noreferrer" target="_blank">http://wiki.mythtv.org/Mailing_List_etiquette</a><br>
MythTV Forums: <a href="https://forum.mythtv.org" rel="noreferrer noreferrer" target="_blank">https://forum.mythtv.org</a></blockquote></div></div><div dir="auto"><br></div><div dir="auto">More than doubling the voltage is never a good idea, my guess would be not enough amperage, I couldn't get reliable operation from internal power supply to a HDHR so I now keep a supply of replacement walwarts on hand.</div><div dir="auto"><div class="gmail_quote"><blockquote class="gmail_quote" style="margin:0 0 0 .8ex;border-left:1px #ccc solid;padding-left:1ex"><br>
</blockquote></div></div></div>