<div dir="ltr"><div><div><div><div>I've been having picture quality issues (macroblocking/momentary signal drops) intermittently since I switched (about a month ago) from capturing video from Comcast cable using Hauppauge PVR-500 adapters (2 stream PCI adapters) to using a Ceton InfiniTV 6 ETH (6 stream ethernet attached) device.  It was suggested that I probably should abandon the distribution amp, so I've collected data reported by the Ceton using the amp, two samples of passive 1:2 splitter, and a barrel (leaving other TV disconnected for testing) as follows (varied from stream to stream in reporting):<br><br></div><div>                              S/N (dB)      Signal (dBmV)<br></div>With amp:               34.0 +/- 0.3       -1.2 +/- 0.2<br></div></div>With splitter #1:       36.7 +/- 0.5       -10.6 +/- 0.4<br>With splitter #2:       36.6 +/- 0.4       -10.8 +/- 0.3<br></div><div>With barrel:              38.5 +/- 0.1       -6.1 +/- 0.3<br><br></div><div>I have two questions:<br><ol><li>Is the unamplified signal level of -10.7 dBmV is more of a problem than the benefit of an additional 2.5 dB of S/N is worth?</li><li>Should I get a different splitter (direct from Comcast, as recommended previously) because the ones I tested are too lossy (more than an extra dB vs. the barrel and the 3 dB that resulted from splitting the signal in half)?</li></ol><p>--</p><p>Craig.<br></p></div></div>