<div dir="ltr"><div><div><div>Gary,<br><br></div>Thanks for the suggestions. I've already started chasing those possibilities down.<br><br>I found one unused cable wall plate that was connected to my distribution amp and replaced the cable with a termination, but that didn't do anything to the S/N.  Since I'm currently only using two of the four outputs on the amplifier, I may try and see what happens if I replace it with a passive two port splitter -- I know the signal level will (probably) be lower, but it would eliminate any noise introduced by the distribution amp.<br><br></div><div>Testing at the demark will have to wait for later.<br></div><div><br></div>In regards to the QoS question, I'm not sure if this applies because the Ceton is connected to a port on an unmanaged etherswitch (Trendnet TEG-S80g, to be specific) and the MythTV BE is connected to another one on the same etherswitch. If I understand correctly, if QoS were even controllable on the LAN, I'd have to have a managed etherswitch/router to set it up, or is there another hole in my "knowledgebase"?<br></div><div></div><div><br>--<br></div>Craig.<br></div>