<div dir="ltr"><div><div><div>I was of half a mind to start a new thread for this question, but it really does apply to the same subject, so, here's the new question about migrating:<br><br>I have had an SD lineup that works perfectly for my Comcast cable feed with my Hauppauge PVR-500s. I just successfully ran a recording on one tuner in the Ceton InfiniTV 6 ETH that I configured over the last couple of days, including getting the CableCard provisioned.  I was in the backend setup adding the other five tuners and also had a couple of lineup changes to make, so afterwards I did a manual update (command line: mythfilldatabase --dd-grab-all) of the database.<br><br></div>Watching the log output, I noticed these lines which raised the associated questions:<br><br>1):<br>2016-12-21 09:48:09.117791 N  SourceUtil::IsProperlyConnected(): Connected to 0 analog, 0 digital and 0 virtual tuners<br>                        Can not mix digital with other tuning information.<br><br></div><div>Don't like seeing zeros for all the tuner types, although I don't think the virtual tuner count is an issue for me.  Should the analog and digital counts be non-zero? If so, what might be causing them to be zero?<br><br></div><div>2):<br>2016-12-21 09:48:09.117810 N  SourceUtil::IsProperlyConnected(): Source ID 1 appears to be connected<br>                        to 4 encoders, and 6 non-encoders. This is probably a bad idea.<br><br></div>Does this mean I need to set up a separate source for the Ceton tuners?  What/where do I make changes? Schedules Direct? mythtv-setup? <br><br>--<br></div>Craig.<br></div>