<p dir="ltr">Good morning!</p>
<p dir="ltr">How you are all well. I have recently updated my system by reinstalling. I used the mythbuntu 16.04 64bit iso and fully patched the system post install.</p>
<p dir="ltr">I've not seen this issue before, the system works fine if I boot with the TV on but when I turn off the monitor or switch it to another input and then return the TV is blank with no signal reported.</p>
<p dir="ltr">I'm using an Intel integrated graphics and i3 fourth gen</p>
<p dir="ltr">I have tried to get X to create a config file but X is refusing:<br></p>
<p dir="ltr">Sudo Xorg -configure</p>
<p dir="ltr">        Before reporting problems, check <a href="http://wiki.x.org">http://wiki.x.org</a><br>
        to make sure that you have the latest version.<br>
Markers: (--) probed, (**) from config file, (==) default setting,<br>
        (++) from command line, (!!) notice, (II) informational,<br>
        (WW) warning, (EE) error, (NI) not implemented, (??) unknow<br>
n.<br>
(==) Log file: "/var/log/Xorg.0.log", Time: Sun Aug 21 11:47:18 201<br>
6<br>
List of video drivers:<br>
        amdgpu<br>
        vmware<br>
        nouveau<br>
        ati<br>
        radeon<br>
        intel<br>
        qxl<br>
        vesa<br>
        fbdev<br>
        modesetting<br>
No devices to configure.  Configuration failed.<br>
(EE) Server terminated with error (2). Closing log file.<br>
:~$<br>
 <br>
 I've also tried with :0 and :1<br></p>
<p dir="ltr">Here is the beginning of the output from lspci</p>
<p dir="ltr">Lspci<br>
00:1c.3 PCI bridge: Intel Corporation 9 Series Chipset Family PCI E<br>
xpress Root Port 4 (rev d0)<br>
00:1c.4 PCI bridge: Intel Corporation 9 Series Chipset Family PCI E<br>
xpress Root Port 5 (rev d0)<br>
00:1d.0 USB controller: Intel Corporation 9 Series Chipset Family U<br>
SB EHCI Controller #1<br>
00:1f.0 ISA bridge: Intel Corporation 9 Series Chipset Family Z97 L<br>
PC Controller<br>
00:1f.2 SATA controller: Intel Corporation 9 Series Chipset Family<br>
SATA Controller [AHCI Mode]<br>
00:1f.3 SMBus: Intel Corporation 9 Series Chipset Family SMBus Cont<br>
roller<br>
02:00.0 Ethernet controller: Realtek Semiconductor Co., Ltd. RTL811<br>
1/8168/8411 PCI Express Gigabit Ethernet Controller (rev 0c)<br>
03:00.0 Ethernet controller: Realtek Semiconductor Co., Ltd. RTL811<br>
1/8168/8411 PCI Express Gigabit Ethernet Controller (rev 0c)<br></p>
<p dir="ltr">All the online suggestions say create a config using the above but... It is not playing ball</p>
<p dir="ltr">Any ideas?<br>
Thanks in advance<br>
Rich<br><br></p>
<p dir="ltr">Please excuse brevity and pistakes as this email was composed on a phone.</p>
<p dir="ltr">Best regards,<br>
Richard<br>
</p>