<div dir="ltr">From what I've read about the older ones, they were only outputting 
around 18fps at 1080p, and that was nearly saturating the 100mbit 
network interface due to the MJPEG encoding, so the V3 is a pretty large
 improvement there.  I wouldn't recommend the V2 for capturing content 
for MythTV, the V3 is a much better starting point.<br><br>It may be 
possible to get the newer ones to encode to a full 1920x1080 if the 
settings controls or firmware can be figured out.  <br><div class="gmail_extra"><div class="gmail_quote"><div class="gmail_quote"> <span></span><br><span></span><blockquote class="gmail_quote" style="margin:0px 0px 0px 0.8ex;border-left:1px solid rgb(204,204,204);padding-left:1ex"><span>
</span>So can several of these be present on the LAN at the same time?<br></blockquote><div><br></div><div>I'm not sure if they would automatically adjust to use different addresses, but with the newer version it is possible to change the destination ip address from a multicast address to a unicast address, so it would be possible with some manual setup.  These changes are not saved by the device however, so it would need to be done each time the adapter is reset.<br></div><div> </div><blockquote class="gmail_quote" style="margin:0px 0px 0px 0.8ex;border-left:1px solid rgb(204,204,204);padding-left:1ex">
The initial blog said or suggested that the transmitter and the receiver<br>
needed to be interconnected directly, i.e. by means of a point to point<br>
Ethernet link, but the product page for the V3 variant of this thing on<br>
Amazon says that they can be connected to a LAN.<br>
<br>
Hence my question: can several of these transmitters coexist on the same<br>
LAN, and if so how does one address them individually?<br>
</blockquote></div></div><br></div><div class="gmail_extra">They will work through network switches as long as the switches will pass multicast traffic, or by changing the destination IP.  When the adapter initializes, it will DHCP an address from the network allowing access to a web interface through which it is possible to change the destination address via a CGI interface.  The full functionality of that interface hasn't been uncovered yet however.<br></div></div>