<div dir="ltr"><div class="gmail_extra"><br><div class="gmail_quote">On Tue, Sep 29, 2015 at 6:33 PM, Richard Woelk <span dir="ltr"><<a href="mailto:richardwoelk@gmail.com" target="_blank">richardwoelk@gmail.com</a>></span> wrote:<br><blockquote class="gmail_quote" style="margin:0 0 0 .8ex;border-left:1px #ccc solid;padding-left:1ex"><div dir="ltr">When my HDPVR 1212 power supplies started going, I cut the ends off and connected them to a hard drive molex from inside the computer. This works well, and the HDPVRs are actually a lot more stable.<div><div>It is probably a good idea to put a fuse in it. </div></div></div></blockquote><div><br></div><div>I am just finishing rewiring my mythtv setup.  </div><div><br></div><div>I have 4 HDPVR's, and 2 usb ports (powering a Raspberry Pi and a little 8 port switch) on the 5v rail and 4 Cisco STB's on the 12v rail all running off a standard ATX powersupply (think it's 400w).  </div><div><br></div><div>Based on the current ratings of all of the equipment's wallwarts, I am well under the rated current on both rails, and I doubt I would ever come close to the theoretical max since the equipment typically draws well under the maximum rating of it's wall wart.</div><div><br></div><div>There is absolutely no doubt that my ATX power supply is more efficient than 10 wall warts would be, and the quality of the power is so much better.</div><div><br></div><div>Took a little while to wire all of the barrel plugs and USB ports... everything is wired to Molex splitters, so I can change the power supply easily if it ever fails.</div></div></div></div>