<div dir="ltr"><div><div><div><div>Hi everyone,<br><br></div>I'm fortunate enough to
borrow a Ceton InfiniTV ETH 6 to play around with for a while and I'm
trying to set it up with mythtv on Ubuntu 13.04 with the mythbuntu ppa
(mythbackend version: fixes/0.26 [v0.26.0-220-g92dbb43]). (It should
also be noted I have never used mythtv before)<br>
<br></div><div>I followed the PCIe instructions as best I could, adding
the tuner as RTP and adding a channel to the channel list. Unfortunately
the frontend says it can't get a channel lock/says 'Signal 100% |
(_L__) Partial Lock', and when I look at the mythbackend output I see
(where 192.168.1.23 is the IP of the Ceton device):<br>
<br></div><div>E CetonSH(192.168.1.23-RTP.0): GetProgramNumber() failed to get a non-zero program number<br></div><div><br></div><div>I
verified that the Ceton device itself works by (in this exact order)
starting VLC on my laptop set to rtp://@:8000, going to the web
interface at 192.168.1.23, going to tuner 1, setting the channel
manually, setting RTP streaming to 'Started' with my laptop's IP, port
8000, and then VLC starts playing that channel.<br>
<br></div><div>I'm also a little confused by the way the tuners are
numbered, as it seems mythtv numbers starting at 0 and the Ceton device
numbers tuners 1-6, so I tried configuring mythtv with tuner 3 but got
the same result (except mythbackend now says 192.168.1.23-RTP.3)</div>
<div><br></div></div>Any advice would be greatly appreciated! Thanks a lot,<br></div>Joe</div>