Yes, but perhaps I misunderstood what that meant ..<br><br>This DTT tuner is on a Hauppauge HVR 4000 card which has a DVB-T and DVB-S2 tuners, both of which cannot be used at the same time.<br><br>I had understood that if I told it to do active EIT scan on the DVB-T tuner, that the card would essentially be permanently assigned to DVB-T ( the DVB-T tuner would either be in use for live/recording, or else it would be collecting EIT) and therefore never available to DVB-S2 at all ...<br>
<br>So in setup I have "open on demand" turned on and "active EIT" turned off too.<br><br>Am I wrong about that? Will active EIT scanning not lock out the DVB-S2 frontend on that same card?<br><br><div class="gmail_quote">
On Mon, Nov 29, 2010 at 10:28 PM, Richard Morton <span dir="ltr"><<a href="mailto:richard.e.morton@gmail.com">richard.e.morton@gmail.com</a>></span> wrote:<br><blockquote class="gmail_quote" style="margin: 0pt 0pt 0pt 0.8ex; border-left: 1px solid rgb(204, 204, 204); padding-left: 1ex;">
I think I understand that you are not looking to do recording at all,<br>
just update your EPG info...<br>
<br>
Why not just set one of your tuners to use active EIT in the tuner<br>
setup. Whenever the tuner is free it'll go of and pick up the EIT from<br>
each of the multiplexes.<br>
<br>
youre quite right that passive eit is collected while a tuner is tuned<br>
into a particular multiplex, but active eit does the epg update for<br>
you...<br>
<br>
R<br>
_______________________________________________<br>
mythtv-users mailing list<br>
<a href="mailto:mythtv-users@mythtv.org">mythtv-users@mythtv.org</a><br>
<a href="http://mythtv.org/cgi-bin/mailman/listinfo/mythtv-users" target="_blank">http://mythtv.org/cgi-bin/mailman/listinfo/mythtv-users</a><br>
</blockquote></div><br>