As of yesterday morning or so, my firewire sa4250_ch stopped working
(was working last six months). I unplugged power from the SA4250 and
let it sit about 15 seconds. I shutdown MythTV. I also tried the
other FW port on the STB. Usually when the channel change request is
done, I can see it on the LCD of the STB, this does not happen. I
tried the test-mpeg2 -r 1 > test.mpg, which actually works, all
though playback is not smooth. So FW is working to some extent, but
not channel change. Priming in the past has done pretty much nothing
and just fails like nuts, so I did not even try it (and don't even use it as sa4250_ch just works fine for last six months without priming).<br>
<br><br>./sa4250_ch 2 -v<br>node 0: vendor_id = 0x000090a9 model_id = 0x00000000<br>node 1: vendor_id = 0x00001ac3 model_id = 0x000010cc<br>Device acquired on node 1<br>Changing channel 2<br>AV/C Command: cmd0=0x00487ce7 cmd1=0x04000200 cmd2=0xff000000<br>
<br>I am on MythDora 5. For the sa4250_ch I had to add in the SA4250 vendor and model ids. <br><br>I
see on the STB info screens a lot of firmware had dates of August
2008. It sounds like something has changed on the STB where it is not
recognizing the channel change request.<br>
<br>plugreport<br>Host Adapter 0<br>==============<br><br>Node 0 GUID 0x0090a94008005308<br>------------------------------<br>libiec61883 error: error reading oMPR<br>libiec61883 error: error reading iMPR<br><br>Node 1 GUID 0x001ac3f83c5c0000<br>
------------------------------<br>oMPR n_plugs=1, data_rate=2, bcast_channel=63<br>oPCR[0] online=1, bcast_connection=0, n_p2p_connections=1<br> channel=0, data_rate=2, overhead_id=0, payload=146<br>iMPR n_plugs=0, data_rate=2<br>
<br>Any ideas?