<br><br><div><span class="gmail_quote">On 12/03/2008, <b class="gmail_sendername">Ronald Frazier</b> <<a href="mailto:ron@ronfrazier.net">ron@ronfrazier.net</a>> wrote:</span><blockquote class="gmail_quote" style="border-left: 1px solid rgb(204, 204, 204); margin: 0pt 0pt 0pt 0.8ex; padding-left: 1ex;">
> > It always displays<br> > > only channels on the current tuner.<br> ><br> > OK. My impression is that there should have been more channels then. I<br> > should have seen all channels on the same multiplex as Film4 right?<br>
<br> <br>It should display all channels that are configured for the particular<br> tuner thats in use. Ideally, that would be everything it's capable of<br> receiving, but maybe you don't have them all setup. Try the following:<br>
Run the mythtv-setup program, go into the Input Connections, and see<br> what video source is attached to that tuner. Then go into the Channel<br> Editor section. This will display all the channels on your system, but<br>
down below there is a box where you can choose to filter it by a<br> single video source. Do that and then look at the list of available<br> channels. If you don't see all the channels, that may be your problem.<br> However, if you see channels listed that you aren't able to browse to<br>
on that tuner, then I'm not sure.</blockquote><div><br><br>I only have one video source which is linked to both tuners in Input Connections. All my channels are attached to that one video source. <br></div><br><br></div>
<br>-- <br>Paul Mason