Been trying to setup Myth with my SG2100 Rotor.&nbsp; It appears that none of the features work.&nbsp; I try USALS, it overscans the sat.&nbsp; <br><br>My true south sat. is located at 91W.&nbsp; I set the roto at 0 and rotate the assembly (dish and motor.. keeping it at 0) aim the dish at 91, check with my ExpressVU reciever and have verified that this indeed is ExpressVU -91.&nbsp; I have Myth use my rotor as a USALS (goto X) rotor and enter in 91.&nbsp; I do a scan and watch as my signal goes from perfect to nothing.&nbsp; I look outside and see my dish has moved 13 degrees to the east.&nbsp; I enter in an different number and it just keeps moving, or going in different directions.&nbsp; I adjust my Longitude and try to scan again.&nbsp; Regardless of what I enter the motor doesn&#39;t change positions.&nbsp; It appears to &quot;know&quot; where the position is and won&#39;t let me get away from it.&nbsp;&nbsp; 
<br><br>I try to use it as a DiSeqc 1.2 and store my positions.&nbsp; I spent a good 20 min figuring out what it was doing and finally came to the conclusion it was using the preset stored positions and not what I enter, or aim at.&nbsp; Anything after 26 (the # of presets the SG2100 has stored) and the rotor doesn&#39;t move.&nbsp; Its stationary.&nbsp; The only positions it knows are the preset ones (for Europe) and refuses to re-write the table in the rotor to store different positions.
<br><br>If anyone has any idea of whats going on or can help by either shooting me a link to a website, etc let me know.<br><br>Thanks in advance!!<br><br>Sean<br>