I'm trying to get Myth working on an older system (P4 1.7 GHz, Hauppage WinTV Go tuner card connected via minijack to SB Live value card, GeForce3 video card) so that I would have a convenient way of recording TV shows - I'm not all that concerned about audio or video quality.  I installed it using the Mythdora distro, and everything seems to be working fine save audio.  I've hit a snag because I can't figure out why my audio lags behind my video - sometimes it's by several seconds... sometimes it's only off by seemingly less than a second.  Also, after I exit "Watch TV" mode, I still get the sound from whatever channel I had been on and it continues to stay on even after exiting the frontend until I open another program that makes use of the tuner card.  After I close that second program, the audio stays off.  I have the line in muted, but set to record.  After playing with mixer settings, I found the sound coming from the TV tuner only goes away after setting PCM to mute.
<br><br>The fact the gap between audio and video never seems to be the same made me think that the computer was just too slow and that video encoding just couldn&#39;t keep up, but then the fact that sound stayed on after exiting the frontend made me think the sound is not setup correctly, either in Myth or elsewhere.&nbsp; Is the first scenario even possible?&nbsp; As for the second scenario, everywhere I&#39;ve searched says make sure the line in is muted, and I&#39;ve already ruled that out.
<br><br>Any ideas for fixes, or things to check would be greatly appreciated.&nbsp; I&#39;m at a loss as to where to go at this point.<br>