Hello everyone,<br><br>My myth box (over CentOS 4) used to be housed in an old beige dell case. When the power supply blew out and the OEM replacement was $75 or so I ended up just getting a new mobo, case, the works. Setup went fine, only, /dev/video0 no longer exists on the "new" system.<br><br>lspci is aware of the card...but I have no idea how to go about mapping this back to a device so I can use myth again!<br><br>here's the output from lspci -vv:<br><br>00:0c.0 Multimedia video controller: Internext Compression Inc iTVC16 (CX23416) MPEG-2 Encoder (rev 01)<br> Subsystem: Hauppauge computer works Inc. WinTV PVR 150<br> Control: I/O- Mem+ BusMaster+ SpecCycle- MemWINV- VGASnoop- ParErr- Stepping- SERR- FastB2B-<br> Status: Cap+ 66Mhz- UDF- FastB2B- ParErr- DEVSEL=medium >TAbort- <TAbort- <MAbort- >SERR-
<PERR-<br> Latency: 32 (32000ns min, 2000ns max), Cache Line Size 08<br> Interrupt: pin A routed to IRQ 177<br> Region 0: Memory at e8000000 (32-bit, prefetchable) [size=64M]<br> Capabilities: [44] Power Management version 2<br> Flags: PMEClk- DSI- D1- D2- AuxCurrent=0mA PME(D0-,D1-,D2-,D3hot-,D3cold-)<br> Status: D0 PME-Enable- DSel=0 DScale=0 PME-<br><br><br>Any ideas? Thanks!<br><br>--Pete<p> 
<hr size=1>How low will we go? Check out Yahoo! Messenger’s low <a href="http://us.rd.yahoo.com/mail_us/taglines/postman8/*http://us.rd.yahoo.com/evt=39663/*http://voice.yahoo.com"> PC-to-Phone call rates.