Hi,<br>
I am trying to Transcode the myth recording but I am getting errors while doing the same through command line.<br>
I wanna get two seperate files for audio and video from the mpeg file.<br>
I followed the instructions in <a href="http://www.mythtv.org">www.mythtv.org</a> and tried the same but I was encountered with the following error.<br>
<br>
linux:~ # mythtranscode --chanid 1012 --starttime 2006-07-28T20:10:00 --profile autodetect --fifodir . --fifosync<br>
2006-07-29 15:39:10.640 Using runtime prefix = /usr/local<br>
2006-07-29 15:39:10.651 New DB connection, total: 1<br>
2006-07-29 15:39:10.657 Enabled verbose msgs: important<br>
2006-07-29 15:39:10.659 New DB connection, total: 2<br>
2006-07-29 15:39:10.675 Using protocol version 26<br>
[mpeg @ 0x40901360]Parser not found for Codec Id: 94210 !<br>
0: start_time: 0.036 duration: 2.066<br>
1: start_time: 1300.914 duration: 2.084<br>
2: start_time: 0.025 duration: 2.050<br>
stream: start_time: 0.276 duration: 14477.480 bitrate=8 kb/s<br>
Couldn't create fifo for file: ./vidout<br>
File exists<br>
2006-07-29 15:39:10.752 Error initializing fifo writer. Aborting<br>
<br>
Was there any error with my options???<br>
Please suggest me<br>
I built myth tv on SuSE 10.0 with Hauppauge 150 card.<br>
<br>
How can I succeed in transcoding?<br>
Even I tried transcoding maually ...I did like this.............watch recordings>job options>begin transcoding<br>
but after checking in Information center it is showing that Transcode job failed due to error!<br>
how to proceed now?<br>
Please suggest me!<br>
<br>
Thanks<br>
<br>
Raj.<br>