[mythtv-users] IR Blaster with Spectrum STB
Greg
gregl at nycap.rr.com
Wed May 6 13:27:18 UTC 2020
On 5/5/20 5:45 PM, mythtv wrote:
> Is any using an IR blaster with the following equipment? I just got
> Spectrum and cannot find a working solution to change channels.
> I have 2 rs232 serial blasters that worked with uverse but for some
> reason are not working well so I'm thinking about building a
> multi-blaster from a raspberry pi. I can get lirc working but when I try
> to record the codes from the remote, all I get is zeroes:
>
> begin remote
>
> name s4
> bits 0
> flags CONST_LENGTH
> eps 0
> aeps 0
>
> one 0 0
> zero 0 0
> gap 50000
> toggle_bit_mask 0x0
> frequency 38000
>
> begin codes
> BTN_1 0x0
> BTN_2 0x0
> end codes
>
> end remote
>
>
>
> The STBs are an Arris DCX3200 and DCX3220
> The remotes are URC1160.
>
> Please help, my Myth system is completely broken right now.
> _______________________________________________
> mythtv-users mailing list
> mythtv-users at mythtv.org
> http://lists.mythtv.org/mailman/listinfo/mythtv-users
> http://wiki.mythtv.org/Mailing_List_etiquette
> MythTV Forums: https://forum.mythtv.org
I use a pair of DCX3200's with Spectrum,but I use Fire wire on one and
a rs232 changer called MyBlaster (no longer available) on the other..
This setup works flawlessly,and it takes LIRC out of the picture.. What
are your RS232 devices? When I first got mine more than 15 years ago, I
had problems with permissions on the serial ports,so I would look there
first... One other problem I encountered was I needed to add dialout to
my groups..
Greg
More information about the mythtv-users
mailing list