[mythtv-users] MCEUSB transmit not working. Same codes send as receive. Hardware working fine.

[Peter Bennett]

On 03/23/2017 10:46 AM, Mark wrote:
> An update.
>
> I have this small snip of a config I tried and the OK button works on 
> my IPTV box!
>
> Now, why would this be?  Here is the remote config below.  Why would 
> my receive config not work to transmit but this does?
>
> I wish the config was complete but its not.  Only 3 keys....
>
>
> begin remote
> name ser1
> flags RAW_CODES|CONST_LENGTH
> eps 30
> aeps 100
>
> ptrail 0
> repeat 0 0
> gap 96946
>
> begin raw_codes
>
> name 1
> 450 150 300 200 200 600
> 200 200 250 700 250 350
> 250 200 250 200 250 200
> 250 200 200 550 200 400
> 250 550 200 250 250 200
> 200 250 150 450 200
>
> name 2
> 500 150 300 150 250 550
> 250 200 200 750 200 400
> 200 250 200 200 250 200
> 250 550 200 600 200 400
> 150 600 200 250 200 250
> 200 250 200 550 200
>
> name ok
> 500 200 200 250 200 550
> 250 200 150 800 250 350
> 250 200 250 200 150 300
> 200 250 200 550 200 400
> 200 600 200 400 200 400
> 200 750 200 250 200
>
> end raw_codes
> end remote
>

I know from experience that raw codes do not work well, if they work at 
all. Try holding the remote closer to the receiver when recording, or 
get a configuration file that has the correctly interpreted codes.

Peter