[mythtv-users] HDHomerun channel setup problem on 0.27

[Tim Scholl]

Make sure you Define a Video Source That will be used by the tuner,  Then
just do a Cable Scan for QAM channels.
Then use the web interface or Channel Editor to add the required XMLid for
each channel.
Once that's done run mythfilldatabase and you should be good to go.



On Sat, Jan 17, 2015 at 2:27 PM, Eric Sharkey <eric at lisaneric.org> wrote:

> On Sat, Jan 17, 2015 at 2:10 PM, James Paul <james at mauibay.net> wrote:
> > Thanks for the reply! I did not consider that the lack of a cablecard in
> the
> > Prime was my issue and I need to do different steps. I don't see a setup
> > page on the wiki for the non-Prime HDHomerun models I have, it's the
> > original HDHR-US white case with two tuners. Which wiki page steps
> should I
> > follow for these and the Prime sans CC?
>
> As far as MythTV is concerned, the original white HDHR and the newer
> black HDHR dual units with an internal splitter are the same.
>
> http://www.mythtv.org/wiki/Silicondust_HDHomeRun_Dual
>
> Eric
> _______________________________________________
> mythtv-users mailing list
> mythtv-users at mythtv.org
> http://lists.mythtv.org/mailman/listinfo/mythtv-users
> http://wiki.mythtv.org/Mailing_List_etiquette
> MythTV Forums: https://forum.mythtv.org
>



-- 
Tim Scholl
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://lists.mythtv.org/pipermail/mythtv-users/attachments/20150117/0b60e6bd/attachment.html>