[mythtv-users] LIRC v ir-keytable -- Remote Control

[jim]

On 02/09/2015 10:39 AM, Alec Leamas wrote:
> On 09/02/15 16:09, jim wrote:
>>
>> On 02/09/2015 09:54 AM, Alec Leamas wrote:
>>> On 09/02/15 15:34, jim wrote:
>>>
>>>> Some of the keys, such as volume up, result in a temporary pop-up 
>>>> window
>>>> showing a speaker icon with associated increase in volume, but nothing
>>>> is shown by ir-keytable -t on the command line.
>>>
>>> Is it  that the kernel sees your device as a keyboard rather than a
>>> remote? This should be obvious when looking at the dmesg output.
>
>> Here is the relevant part of dmesg. I can't claim to be an expert in
>> reading this output. Is there any significance to rc0/input17 here vice
>> the input14 in the ir-keytable output?
>>
>> [    9.895438] Registered IR keymap rc-rc6-mce
>> [    9.895741] input: Media Center Ed. eHome Infrared Remote Transceiver
>
>> [    9.910085] IR LIRC bridge handler initialized
>> [   10.054795] mceusb 3-4:1.0: Registered Topseed Technology Corp. eHome
>> Infrared Transceiver with mce emulator interface version 2
>> [   10.054798] mceusb 3-4:1.0: 2 tx ports (0x0 cabled) and 2 rx sensors
>> (0x1 active)
>> [   10.054817] usbcore: registered new interface driver mceusb
>
>
> All right, it is indeed a remote.
>
> Now, where are the lost events?
>
> Just a shot in the dark: have you a ir_mce_kbd_decoder  kernel module 
> loaded. What happens if you unload (reboots without) it? Is this 
> module stealing your events (I know nothing more than what the name 
> implies...)
>
> Another way would be to try the lirc bridge.  You might have to enable 
> the lirc protocol for this. After doing so, make a simple "cat 
> /dev/lirc0" and press remote buttons. There should be visible garbage 
> coming from the device for each press. If so, you know for sure that 
> there is timing data passed from the driver. That would be a start.
>
>
> Cheers!
>
> --alec
Alec,

Your earlier question on IR remote vice keyboard got me thinking. I've 
done some more testing and have a new data point of interest.

I wanted to isolate the two units that I am trying to make play 
together: the IR + 2.4Ghz remote from Aerb and the IR receiver from 
TopSeed.  The rf dongle for the remote remained installed in a USB port 
and the IR receiver was disconnected. I dropped out of x to a plain 
console and ran showkey. All keys, except for the four colored ones at 
the bottom, on the "remote" side of the Aerb unit resulted in keycodes 
shown by showkey. The Aerb unit apparently is transmitting key signals 
via the rf capability for most of the "remote" keys. I've not tested 
yet, but it may be sending IR signals as well - the led indicator 
illuminates per key press.

For now I will leave the IR receiver disconnected and focus on remapping 
the received keycodes to something useful for MythTV.

Thanks,

Jim