[mythtv-users] mythfilldatabase finds no schedule info
R. G. Newbury
newbury at mandamus.org
Sun Oct 19 19:17:11 UTC 2014
On 19/10/14 02:13 PM, Tom Ashley wrote:
> Updating source #1 (antenna) with grabber schedulesdirect1
> 2014-10-19 13:38:56.505292 I No channels are configured to use grabber.
> 2014-10-19 13:38:56.505332 I
Not sure which end of the pipe that error refers to.
So first check on the SD website that you have a lineup defined, and
channels enabled (you might get that message if every channel in the
lineup is disabled. Would not hurt to Re-add you lineup, on the lineups
page.
Then, running mythtv-setup check that you have a capture card defined.
[OK)a video source defined (eg OTA and have run a scan if OTA, otherwise
'fetched') [OK] and finally linked the card and input connection in
Videosources.
Since you say you successfully scanned for channels, I suspect that
something is wrong with the last step.
BUT NOTE: check also on the second page of the capture card setup, to
ensure that 'Open card when needed' (or something like that) is checked,
and 'Enable EIT is disabled'... EIT monopolizes the card and messes up
the installation, sometimes. And you don't need it anyway.
HTH. There cannot be much else left to do!
Geoff
More information about the mythtv-users
mailing list