[mythtv-users] Schedules Direct DataDirect replacement service testing

[Bill Meek]

On 10/09/2014 06:06 PM, leo.butler at member.ams.org wrote:
> Robert Eden <rmeden at yahoo.com> writes:
>
>> On 10/2/2014 7:38 AM, Leo Butler wrote:
>>> Done without incident. But it was so transparent as to be invisible:
>>> how can I know that the json service was used? I did
>>>
>>> mythfilldatabase --dd-grad-all
>> The JSON service was not used, you would know if it was... you'd need to install a JSON grabber and set up lineups.
>>
>> You tested a drop-in replacement for Tribune Media Services' Data
>> Direct service, developed and hosted by SD.  It's less efficient and
>> less featured than the SD JSON service, but I hope it is "good enough"
>> for folks that don't want (or can't) move.
>
> I have been using the new service since you made this announcement. It
> has worked fine for 1 source (digital cable) but not another (analog
> cable). I have pasted the log file at
>
> http://pastebin.com/RwCkRXFF
>
> My cable supplier (CableOne in Fargo ND) runs both a digital and an
> analog signal on the same line, and I have an old pvr-150 that I use in
> addition to an hdhr3-cc. But I haven't seen any listings or recordings
> for this analog service since I changed over.

Thanks for the log.

    CoreContext datadirect.cpp:1029 (DDPost) - Downloaded 1633668 bytes
    CoreContext datadirect.cpp:1036 (DDPost) - Uncompressed to 19477801 bytes

That's roughly the same as I get. Robert, if you've got his data, it should
probably match the Uncompressed size. It doesn't appear to be a download
issue.

    Updating source #1 (sd-cable) with grabber schedulesdirect1
    Found 58 channels for source 1 which use grabber
    ...
    Updating source #2 (sd-digitial) with grabber schedulesdirect1
    Found 110 channels for source 2 which use grabber
    ...
    Updating source #3 (sd-antenna) with grabber schedulesdirect1
    No channels are configured to use grabber. <-----------------
    ...
    DataDirect: Not inserting channels into disconnected source 3. <----------

Leo, if you remove the entry in /etc/hosts and run it again, do the above lines
look the same?

If "analog cable" = source #1 sd-cable, then it looks like it's working.
However, sd-antenna doesn't appear to be setup completely.


-- 
Bill