[mythtv-users] Wake up frontend with remote
Gary Buhrmaster
gary.buhrmaster at gmail.com
Sat Aug 23 15:31:28 UTC 2014
On Sat, Aug 23, 2014 at 2:43 PM, Josu Lazkano <josu.lazkano at gmail.com> wrote:
....
> I try to enable some of them, but nothing change:
>
> echo USB1 > /proc/acpi/wakeup
These are just guesses, but.....
Presuming that your BIOS supports wakeup properly,
since your device is on bus 2, I would nominally
expect to require USB2, not USB1, but in any case,
the "other" places you may need to adjust are at
/sys/bus/usb/devices/<usb-hub-device>/power/wakeup
<usb-hub-device> is likely to mean both usb2 (in
your case) and (possibly) 2-1 (for the root hub) and
2-5 (for the actual device), and you have to set
the wakeup to enabled (it usually starts as
disabled). Probably for testing to determine if it
works at all just enable wakeup for everything.
Note that it is not unusual that if you hotbplug the
remote that the device numbers may be different.
You may need to use various udev rules to insure
consistent naming or automatic settings of the
wakeup flags.
More information about the mythtv-users
mailing list