[mythtv-users] FW load problem after replacing Hauppauge cards
Jay Ashworth
jra at baylink.com
Tue Nov 26 18:25:28 UTC 2013
----- Original Message -----
> From: "Jay Ashworth" <jra at baylink.com>
> > From: "Devin Heitmueller" <dheitmueller at kernellabs.com>
>
> > It probably makes sense as a test to yank one of the cards out and
> > reboot, so you can see which of the tuners failed to load firmware.
> > This will also help ascertain if it's some sort of race condition
> > related to the tuners being initialized in parallel.
>
> Well, if either card is the only one, then all its relevant firmware
> loads properly.
>
> Yay.
>
> I guess the next thing is to swap slots. I only have 2 -- getting a
> motherboard over the counter with more than 2 PCI slots is effectively
> impossible these days.
The -500 will load both tuner's firmware only if the -150 is not plugged
into the bus.
Ok; I'll try the new and old -500s; that'll teach it.
Cheers,
-- jra
--
Make Election Day a federal holiday: http://wh.gov/lBm94 100k sigs by 12/14
Jay R. Ashworth Baylink jra at baylink.com
Designer The Things I Think RFC 2100
Ashworth & Associates http://baylink.pitas.com 2000 Land Rover DII
St Petersburg FL USA #natog +1 727 647 1274
More information about the mythtv-users
mailing list