[mythtv-users] mythfilldatabase not automatically running since upgrade to .27
Zig
jzigpublic at gmail.com
Tue Dec 3 19:01:20 UTC 2013
On 12/3/2013 12:43 PM, Gabe Rubin wrote:
>
>
>
> On Tue, Dec 3, 2013 at 10:40 AM, Daniel Frey <dmfrey at gmail.com
> <mailto:dmfrey at gmail.com>> wrote:
>
>
>
>
> On Tue, Dec 3, 2013 at 1:35 PM, Gabe Rubin <gaberubin at gmail.com
> <mailto:gaberubin at gmail.com>> wrote:
>
> Hi List,
>
> I may just need a reminder, but how do I set up
> mythfilldatabase to run automatically? Since upgrading to .27,
> it is not doing this anymore. Fortunately, I noticed on
> thanksgiving I had no data and ran it manually, but would like
> to avoid this or using the old cron job method.
>
> Thanks
>
> _______________________________________________
> mythtv-users mailing list
> mythtv-users at mythtv.org <mailto:mythtv-users at mythtv.org>
> http://www.mythtv.org/mailman/listinfo/mythtv-users
>
>
>
> Check your backend status page on mythweb. See if you have a
> message that it ran but there were issues and no data was loaded.
> I have been having that since upgrading to 0.27 and periodically
> have to manually run it on the command line.
>
>
> Just checked it and nothing like that. I do notice that it does not
> say when it will run again, which I believe it used to do:
>
> Last mythfilldatabase run started on Thu Nov 28, 4:02 PM and ended on
> Thu Nov 28, 4:03 PM. Successful.
> There's guide data until 2013-12-13 06:00:00 (10 days).
> DataDirect Status: Your subscription expires on Thu Jun 19 (2014)
> 10:21 PM
>
>
The frontend interface still reports when the next run is scheduled
for. In the frontend goto:
Information Center => System Status => Listings Status
In my case mythfilldatabase was running fine for months, then suddenly
stopped running and oddly the next scheduled date run time was always 1
day in the past. Each day the scheduled run time was updated but still
a day old so mfdb never ran anymore.
I had the backend setup to use the suggested times from Schedules
Direct. What got it going again for me was to uncheck the "get
suggested time from grabber" box and set the guide data execution window
to 0 and 23 (max window size) and did a run manually. After two days
everything was back in sync. I reduced the window size to 0 and 7 and
everything still works. I assume I could go back to using suggested
times, but I haven't tried that again.
Ziggy
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://www.mythtv.org/pipermail/mythtv-users/attachments/20131203/446a4465/attachment.html>
More information about the mythtv-users
mailing list