[mythtv-users] New installation - worked for a while then no more
nick.rout at gmail.com
Sat Nov 10 21:19:03 UTC 2012
On Nov 11, 2012 12:38 AM, "Mark Wigmore" <mawigmore at gmail.com> wrote:
> D'oh! Just found one adaptor had lost it's LNB setting. Distinctly
remember setting both up...
I don't use DVB-S any more but did find that sometimes the lnb settings
just didn't stick and had to be redone a couple of times.
> On 10 November 2012 09:19, Mark Wigmore <mawigmore at gmail.com> wrote:
>> On 9 November 2012 22:03, Stephen Robertson <stephengrobertson at gmail.com>
>> > In the setup logs there are diseqc errors. When setting up your
capture card in mythtv-setup there is a setting for this I have missed in
the past, think for your case it needs set to LNB. Sorry that's a bit
vague, I'm not at the pc just now but that may be enough of a clue for
something to try.
>> > Cheers
>> > Stephen
>> Thanks Stephen. It's a dual card and I have set up both feeds to be LNB.
One feed does go through motor, or rotor in Myth-speak, but I don't want
to start moving the dish yet. Do I still need to tell it about the rotor?
Come to think about it, I couldn't do a channel scan with adaptor0, only
>> I tried following the instructions from
http://parker1.co.uk/mythtv_freesat.php and this command worked:
>> scan -x0 /usr/share/dvb/dvb-s/Astra-28.2E | tee channels.conf
>> But when I tried: mplayer dvb://"BBC THREE" it just hung.
> mythtv-users mailing list
> mythtv-users at mythtv.org
-------------- next part --------------
An HTML attachment was scrubbed...
More information about the mythtv-users